This job is no longer available.

You can view related vacancies or set-up an email alert notification when similar jobs are added to the website using the buttons below.

Job Description

Supplier Quality Engineer

The SQ Engineer is responsible to drive systematic and continuous supplier quality assurance being part of a small local team, reporting directly to Regional SQA Manager. Additionally, the job holder would be in charge for activities related to quality improvements, PQP at suppliers, follow-up on activities related to quality.

Tasks:
a) Define and communicate quality requirements for production and production start-ups;
b) Initiate and check corrective quality measures at our suppliers related to known/potential quality challenges on our products;
c) Define quality requirement and tools in local production (e.g., FMEA, PPAP, IQC-level, SPC-level, FQC, etc.);
d) Participate/support project with approval of production and parts;
e) Monitor product quality in the market, actively take part in Supplier selection and part approval process;
f) Conduct routine process audits at key local suppliers’ manufacturing sites to ensure conformance;
g) Identify possible quality risks, continuous improvement opportunities, provide coaching on quality best practices, verify effectiveness of corrective actions and assist in the resolution of quality problems;
h) Ensure process and quality control plans are in place across the supply chain, following up outgoing quality control and incoming quality control;
i) Support introduction of new products into existing and new suppliers as required;
j) Review designs for manufacturability and ability to meet quality targets;
k) Collaborate with and influence product development project teams to design for quality, manufacturing and reliability;
l) Work with engineering to permanently solve technical supplier quality related problems.

Requirements:
a) Relevant degree and 3-5 years of relevant experience within production/quality assurance in production;
b) Good knowledge of quality planning;
c) Knowledge of problem resolution/ root cause analysis (8D etc.);
d) Experience in quality engineering and process/manufacturing engineering;
e) Hands-on production experience in plastic injection molding;
f) Business language is English;
g) Competent in Microsoft Office: Outlook, Word, Excel, and PowerPoint;
h) Competence in relevant ERP system, documentation system;
i) Independent, must be able to "represent alone".

Location:
Budaörs

 
Get Jobs Like This By Email

Contact

Csaba Patko
+36 1 336 2414
 
×